Advertisement
NOTE: When new, the battery may have been shipped in a low charge state. It will take longer to charge the battery initially and several
subsequent charges may also take a little longer, compared with when the battery reaches its optimum performance.
4.2.
USING THE DRILL
Ensure that you have read, understood and comply with all the safety instructions in Section 1
4.2.1. Ensure the direction switch is in the mid (lock) position. Open the chuck and insert the required drill or screwdriver bit.
4.2.2. Select high or low speed by using the selector on top of the casing (high speed for drilling, low for screwdriving).
4.2.3. Select the direction of rotation by means of the forward/reverse selector.
4.2.4. If driving screws, set the required torque by means of the torque selector ring. 1 is the lowest torque setting.
4.2.5. When drilling, turn the selector ring beyond 18 to the drill setting. The torque limiting function is then deactivated.
4.2.6. The LED worklight is lit whenever the trigger is depressed.
4.2.7. When the trigger is depressed, the charge level display is also illuminated. When green, amber and red lights are showing, the charge
level is healthy. As the charge level drops, the indicator lights go out progressively. When just the red light is showing, the battery
requires recharging.
4.2.8. When finished, remove the bit, clean the drill and bit and replace the drill in its case.
4.2.9. Store in a cool, dry place out of the reach of children.
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
Battery removal is detailed in section 4.1.2. Dispose of the battery pack in accordance with local authority guidelines. DO NOT dispose of as
normal waste.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme.
Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable) into
approved containers and dispose of the product and the fluids according to local regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and
Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling information.
NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and component parts without
prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack Sealey Limited
Battery Removal
Environmental Protection
WEEE Regulations
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
01284 757500
01284 703534
CP14VLD
www.sealey.co.uk
sales@sealey.co.uk
Issue: 1 - 04/08/16
Advertisement
