Crestron HD-TX-301-C-E Do Manual

DO
HD-TX-301-C-E
DM Lite Multiformat Switch and Transmitter
DO Install the Device
Mount the device onto a flat surface or rack rail.
Mount onto a Flat Surface
Using four mounting screws (not included), mount the device onto a flat surface such as a wall.
Mount onto a Rack Rail
Mount the device onto the front or rear rail of a rack. Position either the left or right mounting flange
of the device so that the holes align with the holes in the rack. Then, secure the device to the rack
using two mounting screws (not included).
GUIDE
DO Check the Box
QTY ITEM
1 Power Pack, 24 Vdc 1.25 A, 100-240 Vac
DO Connect the Device
Connect the device as required for the application.
Front Panel Connection
SERVICE:
From TT-100
series cable caddy
Rear Panel Connections
HDMI 1-2:
From RGB (VGA)
From HDMI ®
audio/video or component
sources video source
NOTES:
• A power pack is included with the HD-TX-301-C-E. If a power pack is also included with
the compatible receiver, connect a power pack to either the transmitter or receiver. Do not
connect a power pack to both devices simultaneously. Power is transmitted over the cable
that connects the TO RX port on the transmitter to the FROM TX port on the receiver.
• Cabling that connects the TO RX port to the FROM TX port is designed for intrabuilding
use only.
PART NUM.
VGA 3:
AUDIO:
TO RX:
Unbalanced To FROM TX
stereo line level link input of
audio input
DM Lite receiver
2045870
24V
1.25A:
From included
power pack