Table of Contents
Advertisement
Available languages
Available languages
FOR SERVICE TECHNICIAN'S USE ONLY
Wiring Diagram (No payment system) (Figure 9)
IMPORTANT: Electrostatic discharge may cause damage to machine control electronics. See page 1 for ESD information.
NOTE: Schematic shows shifter in SPIN position, lock switch open, and motor off.
Legend
PAGE 20
DO NOT REMOVE OR DESTROY
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the CAE2745 and is the answer not in the manual?
Questions and answers
How is the warranty on parts handled? Repairman says control board is defective. How **** I reimbursed? cae2745fq0 is under warranty for another 12mos
How is the warranty on parts handled? Repairman says control board is defective. How **** I reimbursed? cae2745fq0 is under warranty for another 12mos
Reset does not work
To reset the Whirlpool CAE2745 washer, follow these steps:
1. Place the program selector knob in the 12 o’clock position and wait 3–4 seconds.
2. Turn the selector knob one click counterclockwise.
3. Turn the selector knob one click clockwise.
This process should reset the washer.
This answer is automatically generated
reset does not work
To reset the Whirlpool CAE2745 washer, follow these steps:
1. Unplug the Washer – Disconnect the washer from power by unplugging it or turning off the circuit breaker.
2. Wait for a Few Minutes – Leave the washer unplugged for at least 5 minutes to allow the control board to reset.
3. Reconnect Power – Plug the washer back in or turn the circuit breaker back on.
4. Run a Calibration Cycle – If needed, enter Calibration Mode (refer to the manual) to ensure proper function.
5. Perform a Quick Test – Start a cycle to confirm that the washer is functioning correctly.
If the issue persists, refer to the diagnostic modes or check for error codes.
This answer is automatically generated