Shaver HD-10 Operator's Manual page 32

5. Remove the retaining strap and the upper
spring bracket.
6. Remove upper cylinder rod self-locking nut
(C4) and lock washer (C16) from drive
cylinder piston (C3).
NOTE: Do not reuse self-locking nut (C4).
Replace with a new self-locking nut.
(C3) Drive Cylinder Piston. (C4) Self-Locking Nut.
(C16) Lock Washer.
7. Remove two self-locking nuts (C12) which
were loosened in Step 2. Remove drive
cylinder (C1) and lower spring bracket
(C13) from road lock bracket bolts (B6)
8. Remove two road lock bracket nuts (B7)
and remove road lock bracket (B2) from
main carriage channel (B1).
(B1) Main Carriage Channel. (B2) Road Lock Bracket.
(B7) Road Lock Bracket Nuts.
9a. Slide the main carriage channel
downward.
9b. Remove the springs from the bottom of
the Post Driver between the drive ram and
the main carriage channel, as shown.
10. Remove drive cylinder (C1) by sliding it
out the top of drive ram assembly (A1).
(A1) Drive Ram Assembly. (C1) Drive Cylinder.
11. Get assistance to remove main carriage
channel (B1) by sliding it out the top of
drive ram (A1).
NOTE: For information on cylinder service,
refer to Drive Cylinder Seal Replacement
section.
12. Remove guide blocks (A2) and shims (A3)
from the pins inside the drive ram I-beam.
32