Table of Contents
Advertisement
84
Remote Console to transmit both the screen data to the administrator
machine and keyboard and mouse data back to the host.
If set to Off no encryption will be used. If set to Try the applet tries to make
an encrypted connection. If the connection cannot be established an
unencrypted connection will be used instead. If set to Force the applet tries
to make an encrypted connection. An error will be reported in case the
connection establishment fails.
IP Access Control
This section explains the settings related to IP access control. It is used to limit the
access to a distinguished number of clients only. These clients will be identified by
their IP address from which they are trying to build up a connection.
Enable IP Access Control
Enables access control based on IP source addresses.
Default policy
This option controls what to do with arriving IP packets that do not match
any of the configured rules. They can be accepted or dropped.
Rule Number
This should contain the number of a rule for which the following commands will
apply. In case of appending a new rule, this field will be ignored.
IP/Mask
Specifies the IP address or IP address range for which the rule applies.
Examples (the number concatenated to an IP address with a "/" is the
number of valid bits that will be used of the given IP address):
192.168.1.22/32 Matches the IP Address 192.168.1.22
192.168.1.0/24
0.0.0.0/0
Matches all IP packets with sources
addresses from 192.168.1.0 to
192.168.1.255
Matches any IP packet
P
U
G
RODUCT
SER
UIDE
Hide quick links:
Advertisement
Table of Contents
