Advertisement
GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority and general workshop practice regulations are adhered
to when using this equipment.
WARNING! Disconnect from mains power before changing accessories, servicing or maintenance.
maintain the nailer in good condition (use an authorised service agent).
Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and
will invalidate the warranty.
Use this product in a suitable work area and keep area clean, tidy and free from unrelated materials. Ensure
there is adequate lighting.
WARNING! Always wear approved eye or face protection when operating the nailer.
Remove ill fitting clothing, ties, watches, rings, other loose jewellery, and contain and/ or tie back long hair.
Wear appropriate protective clothing and keep hands and body clear of working parts.
maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Keep children and unauthorised persons away from the work area.
DO NOT use this product for a task it is not designed to perform.
DO NOT operate where flammable gasses or liquids are present.
DO NOT operate if any parts are damaged or missing. This may cause failure and/or injury.
DO NOT carry by the electrical cable.
DO NOT get the nailer wet or use in damp or wet locations.
DO NOT point at other persons or animals.
DO NOT operate if you are tired or under the influence of alcohol, drugs or intoxicating medication.
DO NOT carry the nailer with your finger on the power switch.
When not in use disconnect from the mains power supply, remove the nails from the magazine and store in
a safe, dry, childproof area.
2. INTRODUCTION AND SPECIFICATION
GS/TUV approved 230V electric nailer. Can take15-32mm nails firing up to 20 per minute. Quick release
magazine cover. Suitable for fastening a wide range of materials from upholstery to timber. Soft grip handle for
comfort and control. fitted with ASTA/BS approved non-rewirable plug.
Nail Capacity: . . . . . . . . . . . . . . . . . . . . . . . 15-32mm
Replacement Nails (Packs of 1000):
. . . . . . . . . . . . . . . . . . . . . .AK7063.04 (15mm)
. . . . . . . . . . . . . . . . . . . . . .AK7063.05 (20mm)
. . . . . . . . . . . . . . . . . . . . . .AK7063.06 (25mm)
. . . . . . . . . . . . . . . . . . . . . .AK7063.07 (30mm)
3. OPERATING INSTRUCTIONS
LOADING NAILS
3.1.1 Ensure the nailer is not plugged into the mains while nails are being loaded.
3.1.2 Always keep nailer with the exit hole facing away from you, preferably towards the surface to be
nailed.
3.1.3 Release loading mechanism by pressing the release button (fig 1), Hold nailer firmly and be aware that
the magazine will slide out under spring action.
3.1.4 Once the nails are loaded in the loading slot (with the points facing downwards towards the base)
close the loading mechanism (fig 2), making sure it is closed fully and the release button clips back into
place.
USING THE NAILER
3.2
Grip the tool firmly and push the nail exit hole against the item to be nailed and squeeze the trigger.
Note: The nail exit hole must be pressed down firmly as this product is fitted with a safety device in the
head which must be fully depressed before the nail will fire. If you are trying to nail a hard material such as
wood you may find pressing down on the head of the tool with your free hand will improve the nail driving.
Weight: . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.6kg
Original Language Version
AK7064
Issue: 2 - 23/10/09
Advertisement
