Sealey CPNG18.V2 Manual

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. safety
1.1. electrical safety
Warning! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey dealer.
if the used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable Appliance Test)
tested.
electrical safety information, it is important that the following information is read and understood.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
9
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
9
Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correct fuse - see
9
fuse rating in these instructions.
do not pull or carry the appliance by the power cable.
8
do not pull the plug from the socket by the cable. Remove the plug from the socket by maintaining a firm grip on the plug.
8
do not use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or replaced immediately by a
8
qualified electrician.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
Class II products are wired with live (brown) and neutral (blue) only are marked with the Class II symbol;
A) Connect the BROWN live wire to the live terminal 'L'.
B) Connect the BLUE neutral wire to the neutral terminal 'N'.
C) After wiring, check that there are no bare wires and ensure that all wires have been correctly connected.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
do not connect either wire to the earth terminal.
Sealey recommend that repairs are carried out by a qualified electrician.
1.2. General Safety
Always assume that the tool contains fasteners. Careless handling of the tacker can result in unexpected firing of fasteners and
personal injury.
do not point the tool towards yourself or anyone nearby. Unexpected triggering will discharge the fastener causing an injury.
8
do not actuate the tool unless the tool is placed firmly against the workpiece. If the tool is not in contact with the workpiece, the
8
fastener may be deflected away from your target.
Remove battery if the fastener jams in the tool. While removing a jammed fastener, the tacker may be accidentally activated if it there
9
is a power supply attached.
Use caution while removing a jammed fastener. The mechanism may be under compression and the fastener may be forcefully
9
discharged while attempting to free a jammed condition.
do not use this tacker for fastening electrical cables. It is not designed for electric cable installation and may damage the insulation
8
of electric cables thereby causing electric shock or fire hazard.
Recharge only with the charger and the battery packs specified by the manufacturer.
9
ensure the switch is in the off position before inserting battery pack.
9
do not open the battery. Danger of short-circuiting.
8
Protect the battery against heat, e.g., also against continuous sun irradiation and fire. There is danger of explosion.
9
do not short-circuit the battery. There is danger of explosion.
8
Battery leakage (liquid ejection). Under abusive conditions, liquid may be ejected from the battery; avoid contact. If contact
9
accidentally occurs, flush with water. If liquid contacts eyes, flush them with clean water for at least 10 minutes, then seek immediate
© Jack Sealey limited
cordless nail/staple gun 18g 18v
lithium-ion
model no:
Wear protective Wear ear
gloves protection
Original Language Version
cpng18.v2
Keep People Keep away from
Away rain
Recommended fuse rating
5 Amp
CPNG18.V2 Issue 1 19/11/18