Page 1
SSP-H-10-1 110-120V~, 60Hz, 12A For illustrative purposes only. Do not forget to try these other fi ne Intex products: pools, pool accessories, in-home toys, airbeds and boats available at fi ne retailers or visit our website. Due to a policy of continuous product improvement, Intex reserves the right to change specifi...
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English TABLE OF CONTENTS Warning..................3-4 Parts....................Set-up..................... 7-10 Operation..................LED Code Chart................12 Maintenance and Chemicals............13-17 Storage................... 18 Troubleshooting................19 Warranty..................20 Changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English IMPORTANT SAFETY INSTRUCTIONS When installing and using this electrical equipment, basic safety precautions should always be followed, including the following. READ AND FOLLOW ALL INSTRUCTIONS DANGER • Risk of Accidental Drowning. Extreme caution must be exercised to prevent unauthorized access by children.
Page 4
• Do not allow the water in the spa to freeze. Do not turn on the spa when the water is frozen. • Do not use the spa if damaged in delivery and/or malfunctioning in any fashion. Contact the Intex service center for further direction.
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English PARTS Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts. NOTE: Drawings for illustration purpose only. Actual product may vary. Not to scale. S AVE THESE INSTRUCTIONS Page 5...
Page 6
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English PARTS (continued) Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts. REF. NO. DESCRIPTION QTY. PART NO. CONTROL BASE 11931 CONTROL BASE BACK COVER 11719...
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English PRODUCT SPECIFICATIONS Maximum seating capacity: 4 adults Water capacity: 210 gal (795 L) Inner/outer diameter: 59/79 in (149/200 cm) Height: 28 in (71 cm) Bubble air blower: 1.1HP / 110-120 V / 60 Hz Filter pump fl...
Page 8
Lay out all the parts on the ground and make sure all the parts are accounted for. For missing or damaged parts contact the appropriate Intex Service Center listed in the separate “Authorized service Centers” sheet. Safety Sign Card Posting The Safety Sign card included with the manual shall be posted in an area visible to the users of the spa to alert them of the safety rules and warnings.
Page 9
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English SET UP (continued) Press the button to turn on the control unit panel buttons fi rst. Press the button to infl ate the spa tub wall until it is fi rm to the touch but not hard (see drawing 6). IMPORTANT: Do not over infl...
Page 10
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English SET UP (continued) Spa Control Unit Installation Connect the spa control unit to the spa tub (see drawing 10). Hand-tighten the connectors securely. Do not use tools to tighten. Reinstall the back cover (2) to the spa control base (see drawing 11). CAUTION: Back cover must be installed before using the SPA.
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English OPERATION SPA CONTROL UNIT PANEL A: Heat Button B: Celsius/Fahrenheit Toggle Button C: Temperature Increase Button D: Temperature Decrease Button E: Water Filter Button F: Bubble Button G: LED Display H: On/Off Button Once the unit is plugged in, use this button to active the control unit panel On/Off Button:...
Reassemble the control unit back to the tub. Plug the GFCI/RCD and restart all over again. • If problem persists, contact Intex Service Center. Water temperature sensor broken • Contact Intex Service Center. After 72 hours of operation, the pump will hibernate and • Press the...
Do not add chemicals if the spa is occupied. This can cause skin or eye irritation. Concentrated chlorine solutions can damage the spa tub. In no event is Intex Recreation Corp., Intex Development Co. Ltd., their related companies, authorized agents and service centers, retailers or employees liable to the buyer or any other party for costs associated with the loss of spa water, chemicals or water damage.
Page 14
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English SPA WATER CHEMISTRY AND BALANCE Preferred Water Chemistry Reading Minimum Ideal Maximum 2 ppm 2 - 4 ppm 5 ppm Free Chlorine 7.2 - 7.6 60 ppm 80 ppm 120 ppm Total Alkalinity (TA) 100 ppm 150–250 ppm...
Page 15
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English SPA WATER CHEMISTRY AND BALANCE (continued) SPA Water Adjustment How to adjust the spa water chemistry when the levels are off the range. CAUTION: Always follow the chemical manufacturer’s directions, and the health and hazard warnings. Total Alkalinity (TA) Adjustment Remove the spa cover to aerate the water and use the included test strips to check the chemistry level.
Page 16
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English SPA WATER CHEMISTRY AND BALANCE (continued) Lowering pH Lowering pH Using Muriatic Acid From→To Volume Total Alkalinity 8.4→7.2 7.8→7.2 0.028 qt 0.019 qt 120 ppm 26 mL 18 mL 210 gal (800 L) 0.018 qt 0.013 qt...
Page 17
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English MAINTENANCE Spa Tub Drainage Turn off the spa control unit. Connect the drain valve adaptor to a garden hose and point the other end of the garden hose to a suitable draining area (see drawing 14). Remove the drain valve cap from outside of the spa tub and attach the drain valve adaptor to the drain valve (see drawing 14).
(263PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 07/16/2014 English MAINTENANCE (continued) Spa Tub and Cover Air Bladder Repair Use the enclosed repair patch to repair any puncture: • Clean and dry the area to be repaired thoroughly. • Remove the patch backing paper and press patch fi rmly over the puncture. Smooth out the surface to remove any air bubbles under the patch.
BUBBLE AIR BLOWER • Air blower pump is too hot. restart all over again. DOES NOT WORK • If problem persists contact Intex Service Center. • Clean or replace the fi lter cartridge in time. • Dirty fi lter cartridge. FILTRATION PUMP •...
WARRANTY Your PureSpa has been manufactured using the highest quality materials and workmanship. All Intex products have been inspected and found free of defects prior to leaving the factory. This Limited Warranty applies only to the PureSpa listed below. The provisions of this Limited Warranty apply only to the original purchaser and is not transferable.
Need help?
Do you have a question about the PureSpa SSP-H-10-1 and is the answer not in the manual?
Questions and answers