Crankshaft Removal / Inspection - Polaris RZR PRO XP 2020 Service Manual

ENGINE / COOLING SYSTEM
5. Measure each bearing journal in two locations, 90
degrees apart. Replace balance shaft if either journal
is worn below the service limit specification. If worn
past the service limit, replace the balance shaft
assembly.
MEASUREMENT
Balance Shaft Diameter (MAG & PTO):
1.4939 - 1.4946" (37.946 - 37.962 mm)
Service Limit: 1.4921" (37.900 mm)
3.70

CRANKSHAFT REMOVAL / INSPECTION

1. Perform Balance Shaft Removal / Inspection page
3.69
2. For ease of assembly, mark each connecting rod and
end cap.
3. Loosen, remove and discard the four connecting rod
q
bolts . Remove the end caps from the crankshaft
w
.
4. Carefully lift the crankshaft out of the crankcase.
5. Remove the cam chain
t
pump drive chain from the crankshaft.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
e r
, PTO main seal and oil
© Copyright Polaris Industries Inc.