Connecting Interface Cables; Connecting The Console Cable - HP A6604 Installation Manual

Figure 4-34 Loosen the fastening screws
Step4 Holding the handle of the MIM, gently pull out the MIM along the slide rails.
Figure 4-35 Pull out the MIM
The configurations (if any) made on a MIM before you remove the FIP will not be automatically

restored upon reinsertion after you restart the FIP. To keep the configurations, make sure that
the MIM is in position before you restart or reinsert the FIP.
The FIP has long ejector levers. When you remove a MIM from Sub-slot 1 of a FIP, make sure

that your hand does not intervene with the right ejector lever of the FIP.
To protect the removed MIM, place it in an antistatic bag.

If you do not install a new MIM in the slot, install a blank panel to prevent dust from entering the

chassis. For how to install blank panels, refer to
page 4-35.

Connecting Interface Cables

Connecting the Console Cable

Follow these steps to connect the console cable:
Step1 Select a configuration terminal.
The configuration terminal can be a standard ASCII terminal with an RS-232 serial interface, or
a common PC.
Step2 Connect the console cable.
"Installing and Removing a Blank Panel" on