Related Manuals for Alfa Laval GHC-0
Summary of Contents for Alfa Laval GHC-0
- Page 1 INSTRUCTION MANUAL IM 70344-US3 S 9709 G&H RESERVE THE RIGHT TO MINOR CHANGES IN DESIGN AND FUNCTION...
-
Page 2: Table Of Contents
This manual is divided into main sections. - See below. Please note that the drawings on page 19-20 can support when reading the manual. Safety 1. Warning Signs ...., ......2 2. Safety Precautions ........3 1. Unpacking/Delivery ........4 Installation 2. -
Page 3: Safety Precautions
All warnings in the manual are summarized on this page. Pay special attention to the instructions below so that severe personal injury or damage to the pump are avoided. 2. Safety Precautions Installation: observe the technical data (see page 18). Always The pump be electrically connected by author... -
Page 4: Installation
Always check the pump before operation. Read the instructions carefully and pay special - See pre-use check on page 6. attention to the warnings! NOTICE: Please notice that the drawings below only show the principle. 2. Installation observe the technical data (see Always �... -
Page 5: Operation/Control
The pump is fitted with a warning label indicating Read the instructions carefully and pay special correct throttling. attention to the warnings! NOTICE: Please notice that the drawings below only show the principle. 1. Operation/Control SEE NOTICE! Always observe the technical data {see �... -
Page 6: Recommended Cleaning
The pump is designed for cleaning in place (GIP). NaOH Caustic Soda. GIP= Cleaning In Place. HNO 3 Nitric acid. Read the instructions carefully and pay special NOTICE: Please notice that the drawing below only attention to the warnings! show the principle. 3. - Page 7 Read the instructions carefully. The items refer to the drawings and the parts list on Handle scrap correctly. pages 19-24. (1-7*) Remove nuts (8) and yoke (5). Remove pump casing (7) and 0-ring (10) from back plate (9), (use a plastic hammer, if necessary).
- Page 8 Read the instructions carefully. The items ref er to the drawings and the parts list on Lubricate the rubber seals before fitting them. pages 19-24. 4. Assembly of Pump/Fitting the Single Shaft Seal (3-9*) Fit the impeller (6) on the pump shaft (26) Fit and tighten correctly! with the notch inwards and turn it clockwise.
- Page 9 Read the instructions carefully. Lubricate the rubber seals before fitting them. The items refer to the drawings and the parts list on Assembly mandrel: For assembly of flushed shaft seal. pages 19-24. • 5. Assembly of Pump/Fitting the Flushed Shaft Seal (3·9*) Fit and tighten correctly! Fit the impeller (6) on the pump shaft (42) with the notch inwards and turn it clockwise.
- Page 10 The drawing includes all items of the pump. This page shows an exploded drawing of GHC-0 with single shaft seal. They are identical with the items in the Spare Parts List. GHC-0, Single Shaft Seal 56 - -Q 55-�� - � - J �...
-
Page 11: Drawing/Parts List
The items are identical with the items in the Spare Parts The drawing and the parts list include all List. items of the pump. When ordering spare parts, please use the Spare Parts Listi Parts List Pos. Qty. Description Motor Screw Spring washer Adaptor...
Need help?
Do you have a question about the GHC-0 and is the answer not in the manual?
Questions and answers