1. Precautions 1. Precautions 1. Precautions 1. Precautions 1-1. Safety Precautions 1-1. Safety Precautions Follow these safety, serv Follow these safety, servicing and ESD precautions to prevent damage and icing and ESD precautions to prevent damage and to protect against potential hazards such as to protect against potential hazards such as electrical shock.
1. Precautions 1. Precautions 1-2. Servicing Precautions 1-2. Servicing Precautions WARNING: WARNING: An elec electrolytic trolytic capacitor capacitor installed with installed with the wr wrong polarity ong polarity might ex might explode. plode. Caution: Caution: Before servicing units covered by this service manual, read and follow Before servicing units covered by this service manual, read and follow the Safety Precautions section of the Safety Precautions section of...
1. Precautions 1-4. Installation Precautions For safety reasons, more than two people are required for carrying the product. Keep the power cord away from any heat emitting devices, as a melted covering may cause re or electric shock. Do not place the product in areas with poor ventilation such as a bookshelf or closet. The increased internal temperature may cause re.
4. Troubleshooting 4. Troubleshooting 4-1. Troubleshooting Set custom mode as follows before beginning a repair. • Resolution: 1680 x 1050 • H-frequency: 60 kHz • V-frequency: 65 Hz If the screen is blank, check whether the power cord is connected correctly. The circuits to check: •...
4. Troubleshooting 4-2. When the Power Does Not Turn On - When turning on the Power button after connecting the power cable, the LED at the front of the Symptom monitor does not operate. - When turning on the Power button after connecting the power cable, the LED at the front of the monitor does not operate.
Page 11
4. Troubleshooting 4-2-1. Circuit diagrams when the power does not turn on...
Page 12
4. Troubleshooting 4-3-2. Waveforms when no screen is displayed (Analog) ① ③ ④...
4. Troubleshooting 4-4. When a blank screen is displayed (Digital) Symptom - Even though the LED power turns on, the screen is blank when connecting the DVI cable. - Even though the LED power turns on, the screen is blank when connecting the DVI cable. - Check the DVI cable connections.
Page 14
4. Troubleshooting 4-4-1. Circuit diagrams when a blank screen is displayed (Digital)
7. Schematic Diagram 7. Schematic Diagram 7-1. Circuit Descriptions Location Function Remark Scaler Besides the ADC, LVDS, and scaling part, an MCU is embedded as well. All of SE758MRH IC200 them are integrated into one chip. Flash Stores the MCU program embedded in the scaler. It is of a ash type and Memory MX25LV512 rewritable.
Page 23
7. Schematic Diagrams 7-5. Schematic Diagrams (Main PBA) This Document can not be used without Samsungs authorization. DVI Part Scaler : SE758MRH Analgo Part Connector ...
Need help?
Do you have a question about the T220 and is the answer not in the manual?
Questions and answers