Testing The Hardware - Samsung SVMI-20E Installation Manual

6. MMC 740: Download options to configure which ports to download.
7. MMC 741: Select if extension, mailbox, both or neither should be created for each port, and
which subscriber group to create them in.
8. MMC 740: Set SVM AUTO SETUP to YES*
*After configuring your system it is recommended that you return this option to "No" to
reduce boot time for the SVMi-20E.
7.1.3 INITIALIZING THE SVMi-20E
Perform a proper SVMi-20E system shut down.
described in the section Correct System Shutdown.)
Once the SVMi-20E is down and at a C:> DOS prompt, Press the RESET button this will reboot
the SVMi-20E. During the Reboot process the SVMi-20E will communicate through a series of
IPC messages to the MCP to read the MMC data and initialize the SVMi-20E accordingly.
NOTE: After the SVMi-20E restarts you should change the value of MMC 740 so that it indicates
"MBX Download = No." This will prevent the system from overwriting any future changes you
make to the SVMi-20E database.

7.1.4 TESTING THE HARDWARE

1. Call each SVMi-20E port individually and confirm that SVMi-20E answers.
2. Call station group 5039 and confirm that SVMi-20E answers.
If steps 1 and 2 above proved to be successful you have completed the installation and
setup of the SVMi-20E hardware.
You are now ready to begin programming the SVMi-20E Voice Mail/Auto Attendant system
parameters.
NOTE:
other MMCs that interact with the
8. Correct System Shutdown
Whenever possible one of the following procedures should be followed when shutting down the SVMi-20E
system and/or prior to shutting down the Telephone equipment
8.1 Procedure One
From the Main Status Screen (showing activity and port status):
1. From any phone on the system Log into KMMC Programming
2. Using MMC 740 change RESTART SVM from "No" to "Yes"
3. The SDN LED on the front of the SVMi-20E will change from RED to Green. Green means it is safe
to power down the switch.
SVMi-20E Installation / May 2009
See the SAMSUNG SVMi-20E Programming Section.
See MMC references in the SVMi-20E Programming Overview documentation for
†
(Steps for performing a proper shut down are
SVMi-20E.
Home Page
8