ePropulsion VAQUITA Quick Start

1. Install the motor

1.1 Install with a US n box adapter
a) Insert the adapter into the motor base.
b) Place the n screw plate into the n box slot and insert the motor into the
n box. Use a n screw to x it.
1.2 Install with an SUP n box adapter
a) Insert the adapter into the motor base.
b) Slide the adapter into the n box and x the adapter with the retaining clip.
1.3 Install with a universal adapter
a) Install the universal adapter on the boat bottom with two ratchet straps.
b) Attach the motor to the universal adapter.

2. Fix the battery and connect it with the motor

Fix the battery with the bungee cords or a ratchet strap.
Plug the motor cable into the charge/discharge port of the battery and
tighten the connector.

3. Switch on the battery

Press the power button and hold until all battery LEDs light up one by one.

4. Switch on the remote control

Short press its on/o button to switch it on. (LED lights up with a beep.)

5. Start/stop the motor

Wear the remote control around wrist or tie it to a paddle.
Start: Switch on the remote control.Then push the throttle forward to start.
Stop: Normally, push the throttle to zero position to stop slowly.
In emergency, short press the remote's on/o button to stop at once.
Restart: First return the throttle to zero position. Then push the throttle
forward to speed up.

Important Notes:

Do not use VAQUITA in shallow water. Any damage caused by drag
or collision is out of warranty scope.
Users who are allowed to use VAQUITA should be in good physical state,
know how to swim and how to paddle.
Users should always wear a life vest, always wear a leash while using this
product and always take a paddle on board.
Do not run the motor in air.
Quick Start for VAQUITA