Page 32
Product warranty and after-sales service are only valid in Japan. Preparation before use (P.3〜6) Charge before first use. How to charge (P.3) Be sure to charge on a power source of 100 - 120V or 200 - 240V AC. The recommended charging temperature is in the range of 10 –...
Page 33
3. After a lapse of the standard charge time (8 hours), remove the power plug from the outlet. In order to deliver full performance of the battery: (1) In the case of not using the shaver for three months or more, charge before use.
Page 34
<Example of graphic illustration> This symbol means "prohibited" (never do this). "Disassembly prohibited" "Use prohibited with wet hands" "Prohibited use in wet location" "Prohibited to wet" This symbol means "compulsory" (be sure to do). "General activities" "Pull out the power cord from outlet" After reading this manual, the user should preserve it in a place where it can be referred to at any time.
Page 35
Use carefully if you have acne or abrasions on skin. (Breakage causes damage to skin) Regularly clean the power plug so that dust does not form on them. (Cause of electric shocks, short circuits or ignition) After use, make sure to put on the cap. (Cause of damage to skin by breakage or deformation of the outer blade) After operation, keep it in a place free from moisture.
Page 36
How to use (P.13〜15) For initial use, trim while lightly applying the shaver to skin. How to shave with the outer blade (P.13) Check that there is no breakage and deformation of the outer blade before use. (Cause of damage to skin) Never press it strongly to the skin.
Page 37
Maintenance (P.16〜19) Maintenance of the outer blade and inner blade (P.17) Be sure to turn the switch to "OFF." (Cause of injury to fingers) 1. Turn the switch to "OFF," and remove the outer blade holder. 2. Clean the outer blade, inner blade, and body. 3.
Page 38
3. Install a new outer blade. Put the ribs at both ends of the outer blade in the depression of the outer blade holder, and insert the claws of the outer blade holder into the holes of the black guide. Note Do not install the outer blade right-side out or push in the outer blade at a slant.