Replace The Ev Charge Cable - ABB Terra AC Installation Manual

7.5

Replace the EV charge cable

Preliminary requirements
Procedure for EU Models
1. Get access to the EV charge cable connection:
a. Remove the cabinet cover. Refer to section
b. Remove the maintenance cover. Refer to
c. Remove the plastic cover.
2. Disconnect the EV charger 2-pin connector (A)
that is receptable to the CP/CC connector.
3. Loosen the screws (B) on the terminal block
output connector (C).
4. Disconnect the wires:
•
•
•
•
•
5. Remove the EV charge cable.
6. Connect the new EV charge cable:
a. Connect the wires.
b. Tighten the screws (B) to the correct torque. For the specification, refer to section
c. Connect the EV charger 2-pin connector that is receptacle to the CP/CC
7. Prepare for operation:
a. Install the plastic cover.
b. Install the maintenance cover. Refer to section
c. Install the cabinet cover. Refer to section
BCM.V3Y01.0-EN | 001
1. EV charge cable might be
determined to be defective
(refer to Troubleshooting
section or customer
service). The replacement
of the EV charge cable
must be done by an official
electrician
•
Torque screw driver
9.1
.
9.3
section .
L1(D)
L2 (E)
L3 (F)
Earthing wire (G)
Neutral wire (H)
11.16 .
connector.
Electrical installation
•
EV charge cable within the
specifications.
11.13
section .
9.4
.
9.2
.
Refer to
35