Dremel VERSA PC10 Original Instructions Manual page 11

CHANGING ACCESSORIES
To reduce the risk of injury, always be sure the tool is
turned "OFF" before changing accessories, changing
backing pad, removing splash guard, or servicing your
tool.
ATTACHING SPLASH GUARD
To attach splash guard: line up pins on the guard with
the slots on the tool housing. Twist in a counterclockwise
direction until it is snug on the tool. You must attach the
splash guard before attaching the backing pad.
ATTACHING BACKING PAD
To attach backing pad: align with the threads of the
output shank and finger tighten the pad in a clockwise
direction.
ATTACHING ACCESSORIES
Accessories are attached to backing pad by hook-and-
loop system.
To attach: align "loop" side of accessory to "hook" side
of backing pad on the tool. Align accessory as close
to center as possible on the backing pad so it spins
concentrically for optimal performance and ease of use.
The accessories will overhang the backing pad, which
allows the user to get into corners and tight spaces.
To remove: pull the accessory off the backing pad.
Hold the accessory by the "loop" backing material and
peel away from backing pad, rather than grabbing the
sponge/microfiber material.
To attach the bristle brush: first remove the backing
pad completely and then attach brush by aligning the
threads of the output shank and finger tighten the
bristle brush in a counterclockwise direction.
USE
USE ONLY DREMEL VERSA ACCESSORIES.
®
!
OTHER ACCESSORIES ARE NOT DESIGNED
FOR THIS TOOL AND MAY LEAD TO PERSONAL
INJURY OR PROPERTY DAMAGE. Store accessories in
a dry and temperate environment to avoid deterioration.
8
8
8
9
10
ALWAYS COMPLY WITH THE APPLICATION,
!
DISPOSAL AND WARNING INSTRUCTIONS OF
THE CLEANING SOLUTION MANUFACTURER.
Improper use can result in personal injury and property
damage.
The Dremel Versa is designed to work with spray,
foam, gel, or liquid cleaners. Before using cleaning
solutions please read and follow manufacturer's
warnings and instructions for use. Cover the
surrounding area that you are cleaning to protect from
spray. Use splash guard on open surfaces to contain
spray. Recommended to apply water and cleaning
agent to the surface that needs cleaning and/or to the
accessory directly. If applying water or cleaning agent
directly on accessory, shake excess liquid off or "pulse"
the tool by quickly turning it "on" and then "off" in
a contained areas (i.e. bucket or sink) to reduce spray.
To start cleaning, press and release the On/Off button
(Fig. 1) while the accessory is in contact with the
surface to be cleaned. The tool will come up to speed
quickly. Gently press to the surface to be cleaned, do
not press too hard, let the tool do the work. Move the
tool in a circular pattern. Do not hold the tool in one
spot for more than 5 seconds.
To turn the tool off, press and release the on/off button.
ELECTRONIC MONITORING
Your tool is equipped with an internal electronic
monitoring system that helps to maximize motor and
battery performance by limiting the current to the tool
when overload and stall conditions occur.
If you stall the tool for too long the tool will
automatically turn off. Once this happens, simply press
and release the on/off button twice to start the tool
again, and continue using it.
When the battery becomes close to empty, the tool
may shut down more frequently than normal. If this
happens, it is time to recharge the tool.
ACCESSORIES
The kit includes a backing pad, splash guard, and
4 different accessories. Spot-test a small section of the
surface that you intend to clean for acceptability before
cleaning entire job.