Dremel VERSA PC10 Original Instructions Manual page 10

• Do not charge battery in damp or wet environments
• Do not use charger when damaged; take it to
one of the officially registered DREMEL Service
Stations for a safety check
• Do not use charger when cord or plug is damaged;
cord or plug should be replaced immediately at one
of the officially registered DREMEL Service Stations
• Do not use battery when damaged; it should be
replaced immediately
• Do not disassemble charger or battery
• Do not attempt to recharge non-rechargeable
batteries with the charger
• Permitted ambient temperatures (tool/charger/battery):
– when charging 0...+45ºC
– during operation -20...+50ºC
– during storage -20...+50ºC
CHARGING BATTERY PACK
Use power adapter matching charger specification
above to charge Dremel Versa.
Charge Dremel Versa with a USB cable provided by
Dremel. Use of other USB cables may result in tool
and property damage and personal injury.
Your Dremel PC10 does not come completely charged
from the factory. Be sure to charge tool prior to initial use.
1. Insert USB cable "F" into USB port of power adapter
"H". If power adapter is not included, charge tool
using 5V/1A minimum USB power supply.
2. Plug power adapter "H" into standard power outlet.
3. Plug micro USB "E" into Micro USB port "B".
4. The battery charge indicator I indicates the
charging progress.The blue LED light located on
the tool housing below the USB outlet will turn on
to signal the battery is receiving a charge. When
the tool is fully charged (approx. 2 Hrs 45 min.),
charging will automatically stop and the blue LED
light will turn off.
5. It is normal for the handle of the tool to get warm
during charging.
Note: charging function stops while tool is running
and resumes again after tool is turned off.
6. When the battery is fully charged, disconnect the
Micro USB end of the cable "E" from the tool
7. Unplug the power adapter from the power outlet
(unless you are charging another tool).
8. When the battery is depleted, the tool will turn
off automatically. This will be a sudden stop as
opposed to a gradual slow down of the tool.
Simply recharge the tool.
IMPORTANT CHARGING NOTES
Lithium-ion battery will hold its charge while in storage
for up to 2 years so it's always ready when you need it.
• The charger was designed to fast charge the
battery only when the battery temperature is
between 0˚C and 45˚C.
• A substantial drop in operating time per charge
may mean that the battery pack is nearing the
end of its life and should be replaced. For service
of your tool, please contact one of the officially
registered DREMEL Service Stations
• If battery does not charge properly:
a. Check for voltage at outlet by plugging in some
other electrical device.
b. Check to see if outlet is connected to a light
switch which turns power "off" when lights are
turned off.
c. Check USB terminals for dirt. Clean with cotton
swab and alcohol if necessary.
d. Check to see if USB cable is properly
connected to the tool and the power adapter.
e. If you still do not get proper charging, send tool
and power adapter to your Dremel Service Center.
Note: Use of power adapters or battery packs not sold
by Dremel may void the warranty.
ACCESSORIES
ALWAYS TURN OFF THE TOOL BEFORE CHANGING
ACCESSORIES
Use only Dremel tested, high performance
accessories. Be sure to read the instructions
supplied with your Dremel accessory for
further information on its use. Handle and store
accessories carefully.
9