Siemens RDJ100 Series Quick Manual

Quick Guide for Service Interval Reminder Setting
Elements Functions
1
: Time setting position
2 RUN position
3 Programming selector
4 Advance button (override / presence button)
5 Setting knob
Service interval reminder parameter
Parameter Description
SEr Days until next service is due
and boiler service needs to
be arranged.
PrE Pre-warning time
Act Action on service due
The settings will be kept in the non-volatile memory and will not be erased if removing the
battery or performing a reset on the rear side of the thermostat.
A6V11239600_en--_a
RDJ100...
Factory setting Setting range
OFF OFF, 1...400 days
30 days 0...50 days
Warning only (0) 0 = Warning only
1 = 60 mins control with
Comfort temperature,
manually triggered
2018-06-22 Subject to alteration
Enable service reminder
·
Set programming selector to position
·
Press advance button for about 5 seconds until the
display goes blank. Turn setting knob, screen display
will be:
st
o 1
nd
o 2
·
Press advance button once and "OFF" starts flashing
and is ready for adjustment.
·
Adjust the days of next service due day (1...400 days)
by turning setting knob.
·
Press advance button once to confirm the setting.
Note: If service due day is set to "OFF", thermostat will
go back to normal operation (time setting position
·
The display will show:
st
o 1
nd
o 2
·
Adjust pre-warning time to 0...50 days by turning
setting knob.
·
Press advance button once to confirm the setting.
·
The display will show:
st
o 1
nd
o 2
·
Adjust service interval action by turning setting knob:
o 0: warning only
o 1: 60 mins control with Comfort temperature
·
Press advance button once to confirm setting and go
back to normal operation.
Set programming selector to RUN position.
.
line: "SEr"
line: "OFF"
line: "PrE"
line: "0d"
line: "Act"
line: "0"
Siemens Building Technologies / HVAC Products
).