Check Transmission Oil Level - Buhler 435 Operator's Manual

4-4
Section 4 - Lubrication & Maintenance
Every 10 Hours or Daily
Operation 9
Check the Transmission Oil Level
When checking the transmission oil, ensure the
following:
• Check the oil level with the tractor parked on a
level surface with the engine shut off .
• With cold oil, the oil level should show in the sight
glass section designated as cold . Add oil if
necessary to bring the oil level to the bottom of the
cold section of the sight glass .
• With hot oil, the oil level should show in the sight
glass section designated as hot . Add oil if necessary
to bring the oil level to the bottom of the hot section
of the sight glass .
Synchromesh Transmission
The oil level for the Synchromesh transmission is easily
checked by looking at the sight gauge () located on
the rear lower left corner of the transmission case .
The sight gauge has an "ADD" and "FULL" line
indicated on it . If additional transmission oil is
required, remove the cap (2) from the filler tube and
add oil as necessary .
1407 Twindisc Powershift Transmission
The oil level for the 407 Twindisc Powershift
transmission is checked by looking at the sight gauge
located on the rear lower left corner of the transmission
case (3) . If additional transmission oil is required,
remove the cap (4) from the filler tube and add oil as
necessary .
CAT TA22 Powershift Transmission
The oil level for the CAT TA22 Powershift transmission
is checked by looking at the sight gauge located on the
rear lower right corner of the transmission case (5) .
If additional transmission oil is required, remove the
cap (6) from the filler tube and add oil as necessary .
NOTE: Do not operate the transmission with oil levels
above or below the recommended settings. Either
condition can result in overheating or loss of power
and damage to the equipment.
435/485/535
Synchromesh Transmission
3
1407 Twindisc Powershift Transmission
6
CAT TA22 Powershift Transmission
1
2
F4-16
4
F4-17
5
F4-99