Initializing The Meter (Reset); Adjusting The Trim Level To Zero (Trim Level) - Yamaha 6YC INFORMATION STATION Operation Manual

■ Initializing the meter (Reset)

In the "Reset" menu, it is possible to reset the
meter to its default settings.
1. Use the directional keypad and the [SET]
button to select "Reset" in the "MENU"
screen.
2. Use the [ ] (Up/Down) buttons on the
directional keypad to select the item.
Set using the [SET] button.
TIP:
• THIS DEVICE: This meter will be initialized
and restarted.
• ENGINE NUM.: The number of outboard
motors will be initialized. However, the
tank settings (Tank Set) will not be initial-
ized.
• SYSTEM (when mechanical remote con-
trol is connected): Identification numbers
stored in each engine will be initialized.
• CL PLUS GATEWAY (when Digital Elec-
tronic Control is connected): Connected
Command Link Plus gateway will be initial-
ized.
When mechanical remote control is con-
nected
When Digital Electronic Control is con-
nected
■ Adjusting the trim level to zero (Trim
level)
Fully trim the outboard motor down, and then
adjust the trim level to zero.
For details on how to adjust the trim level,
see "Adjusting the trim level to zero"
(page 10).
MENU screen
34