If the device is damaged, turn the device off and do not use until service-trained personnel can check its safety. If necessary, return the device to National Instruments for service and repair to ensure that its safety is not compromised.
National Instruments for service and repair to ensure that its safety features are not compromised. When using the device with high common-mode voltages, you must insulate your signal wires for the highest input voltage. National Instruments is not liable for any damages or injuries resulting from inadequate signal wire insulation.
Page 5
Reinstall the top cover and tighten the top cover screws. 10. Connect the terminal block to the module front connector as explained in the Installation section. Figure 1 shows the SCXI-1325 terminal block parts locator diagram. Back View Front View 1 Strain-Relief Bar 3 Safety-Ground...
Figure 2 shows the SCXI-1325 signal connections. 1 Serial Number 3 Assembly Number 2 Wire Entry Side 4 Product Name Figure 2. SCXI-1325 Signal Connections Installation To connect the terminal block to the SCXI module front connector, perform the following steps: Connect the module front connector to its mating connector on the terminal block.
NI Web Support To provide you with immediate answers and solutions 24 hours a day, 365 days a year, National Instruments maintains extensive online technical support resources. They are available to you at no cost, are updated daily, and can be found in the Technical Support section of our Web site at www.ni.com/support...
Need help?
Do you have a question about the SCXI-1325 and is the answer not in the manual?
Questions and answers