Sealey SA232 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
 Follow all workshop safety rules, regulations, and conditions when using drill.
 WARNING! Disconnect from air supply before changing accessories or servicing.
 Maintain the drill in good condition and replace any damaged or worn parts. Use
genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
 WARNING! Check correct air pressure is maintained and not exceeded. We recommend 90psi.
 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each
use and ensure that all connections are secure.
 Wear approved safety eye/face shield, ear defenders and hand protection.
 WARNING! Due to the possible presence of asbestos dust from brake linings, when working
around vehicle brake systems we recommend you wear suitable respiratory protection.
 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
 Keep children and non essential persons away from the working area.
 DO NOT use the drill for a task it is not designed to perform.
 WARNING! DO NOT use drill if damaged or thought to be faulty. (Contact Service Agent).
 DO NOT use drill unless you have been instructed in its use by a qualified person.
 DO NOT carry the drill by the air hose, or yank the hose from the air supply.
 DO NOT operate drill if you are tired, or under the influence of alcohol, drugs or intoxicating medication.
 DO NOT direct air from the air hose at yourself or others.
 When not in use disconnect from air supply and store in a safe, dry, childproof location.
2. INTRODUCTION & SPECIFICATION
Straight type air drill with machined aluminium body. Unit features planetary gear drive assembly,
built-in air regulator, built in muffler and safety trigger to prevent inadvertent operation. Supplied
with 10mm drill chuck and key. Suitable for general workshop use.
Free speed . . . . . . . . . . . . . . . . . . . . . .2500rpm
Air consumption . . . . . . . . . . . . . . . . . . . . 4cfm
Sound level. . . . . . . . . . . . . . . . . . . . . 89.9dB.A
INSTRUCTIONS FOR:
STRAIGHT AIR
DRILL 10mm
MODEL No:
Operating pressure. . . . . . . . . . . . 90psi
Air inlet size . . . . . . . . . . . . . . . 1/4"BSP
Weight . . . . . . . . . . . . . . . . . . . . 0.9kg
Original Language Version
SA232
SA232 Issue: 2 - 05/11/09