Maclaren techno xt Manual page 7

10 REMOVING AND REFITTING THE SEAT COVER
Remove hood, shoulder pads from buggy if fitted.
A Twist shoulder strap end buckles and feed
through holes.
B The waist harness back strap is fixed to the chassis
behind the seat. To remove, twist the buckles on
each end of the harness back strap and unthread
from the 'D' rings attached to the chassis.
NOTICE: It is important that the strap be rethreaded
through the 'D' rings after the seat has been refitted.
Failure to do so will endanger your child.
C Feed crotch strap buckle through holes.
D Unclip seat cover retaining straps.
E Unfasten seat fabric from handle tubes and
seat base.
F Slide fabric from seat back and base.
G When refitting seat fabric, insert seat back support
tubes into fabric flap.
H When refitting shoulder straps choose the fabric
holes appropriate to the child's size. Twist the buckles
and feed through seat cover, seat back and then
through holes in plastic seat back arms.
J When refitting seat fabric to seat base pass crotch
strap buckle through the hole in the seat fabric and
then hole in seat base.
NOTICE: The seat fabric must be wrapped over the top
of the handle tube and fastened by the button hole.
After assembly pull the seat fabric forward and
backward to ensure it will not come off.
11 TO REFIT THE SHOPPING BASKET
A place bag on the 'X' frame under seat with
lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above
horizontal tie bar.
12 TO FIT THE RAIN COVER
A Return hood to non-tilted position before fitting
rain cover.
B Ensure visor is folded away beneath the hood.
C place the apron over the hood front.
D Attach two eyelets (one each side) to the
hood clips.
E Attach the two eyelets (one each side) to the
front legs.
13 TO FIT HEAD HUGGERS
Unclip shoulder straps from seatbelt clasp, remove
strap from buckle clip and feed straps through holes
in head hugger cushion (height can be adjusted by
selecting upper or lower holes). Reclip shoulder
straps to seat belt clasp.
TO FIT HARNESS PADS (If Supplied):
A Lay open pad under shoulder harness strap.
B Fold pad over and secure adjustable straps.
A
A
C
E
D
G
G
B
A
B
F
F
H
J
C
A
C
B
D
D
E
E
A
B
en
5