Removing The Shipping Struts; Commissioning Twindos - Miele WWH 860 Operating Instructions Manual

3. Removing the shipping
struts

Failure to remove the shipping
struts can result in damage to the
washing machine and to adjacent
cabinetry or appliances.
Remove the shipping struts as
described in "Installation and
connection".
The following message appears in the
display:

Remove shipping struts
 Confirm with the OK sensor button.

4. Commissioning TwinDos

The UltraPhase 1 and UltraPhase 2
values are pre-set in the standard
settings and only need to be confirmed.
The following message appears in the
display:
 TwinDos
 Confirm with OK
The following message appears in the
display:
Set up now
 To set up TwinDos now, touch the OK
sensor button.
 To postpone setup until later, touch
the  sensor button until
appears in the display and press the
OK button to confirm.
Settings for compartment 
The UltraPhase 1 values are pre-set in
the standard settings.

 Confirm with the OK sensor button.
Miele UltraPhase 1
 Confirm with the OK sensor button.
The following will appear in the display:
 Set the dosage. Observe water hardness
levels
 Confirm with the OK sensor button.
The dispensing quantity for
UltraPhase 1 for  (hardness range I)
is pre-set.
Per load
 Confirm the pre-set value with the OK
 Hardness level I
Set up later
 Hardness level II
 Hardness level III
Initial commissioning
 
Agent for 
 
 
 
 
 
sensor button or correct the value
with the  sensor buttons and
confirm this with the OK sensor
button.
UltraPhase 1
OK

OK
48 ml
OK
48 ml
60 ml
72 ml
19