Table of Contents
Advertisement
Securing with screws
Important:
R Make sure the screws are shorter
than the thickness of the installation
surface.
1
Remove the sensor from the
mounting adaptor by pressing the
release lever (A), sliding the
sensor up and lifting it away from
the mounting adaptor (B).
2
Use the screws to attach the
mounting adaptor to the inside of
the garage door.
R Make sure the "UP" mark on
For assistance, visit www.panasonic.ca/english/support
HNS107C_(en_en)_0212_ver.011.pdf
B
A
the mounting adaptor points
upwards when the garage door
is closed.
UP
A
U P
25.4 mm (1 inch)
15
3
Attach the sensor to the mounting
adaptor.
R The sensor will click into place
when it is secured.
R Make sure the "UP" marks on
the back of the sensor and the
inside of the mounting adaptor
point in the same direction.
Setup
15
2016/02/12
9:35:26
Advertisement
Table of Contents
