Setting The User Bit - Canon XA11 Instruction Manual

Setting the User Bit

The user bit display can be selected from the date or the time of recording, or an identification code
consisting of 8 characters in the hexadecimal system. There are sixteen possible characters: the
numbers 0 to 9 and the letters A to F. When you record a scene, the user bit will be recorded with it.
The user bit is also output from the HD/SD-SDI terminal (o only) or HDMI OUT terminal.
Operating modes:
1 Open the user bit [Setting] screen.
[FUNC.] [MENU]
> >
• To set the time for the user bit, select [
[ Date]. Then, touch [
• The user bit setting screen will appear with the orange selection frame on the leftmost digit.
• To reset the user bit to [00 00 00 00], select [Reset].
• Touch [Cancel] to close the screen without setting the user bit.
2 Touch the digit you want to change and then touch [
3 Touch another digit you want to change.
4 Change the rest of the digits in the same way.
5 Touch [OK] and then touch [X].
NOTES
• When the frame rate is set to 23.98P and [FUNC.]
is set to [Pulldown], the user bit will be 2:3 pulldown data.
• When playing back MP4 movies, the user bit embedded in the signal output from the HD/SD-SDI
terminal (o only) and HDMI OUT terminal will have a value of 0 and cannot be changed.
[User Bit Type]
> >
Time] instead; to set the date for the user bit, select
]. The rest of the procedure is not necessary.
X
>
[ Setting]
Í] or [Î ] to change it as necessary.
[MENU] [User Bit Output Mode]
> >
Setting the User Bit
71