2.12
POSITIONING THE TENSION POLE
See Fig. 2-12-1.
Tension Arm Sub
Assembly
D section
Adjustment Method
Note:
• Remove the cassette housing assembly in advance.
1. Set the mechanism mode to the PLAY mode. (See pages
2-20 and 21.)
2. Loosen a screw A .
3. Check the location of the tip (section B ) of the tension
arm assembly to make sure that it is within area C .
If it is located outside, turn part D to bring it within the
specified area.
4. Tighten the screw A .
Note : Tightening torque for the screw A : 0.06 N . m (0.6
kgf . cm)
2-38
B section
C
Screw A
Fig. 2-12-1