JVC UX-A52 Service Manual page 8

UX-A52
Removing the front panel assembly
Prior to performing the following procedure, remove
the rear cover, the side panels, the top panel and the
system control board.
1. Release the two joints d on the lower right and left
sides of the front panel assembly, then remove the
front panel assembly toward the front.
Removing the headphone jack board
Prior to performing the following procedure, remove
the rear cover, the side panels, the top panel, the
system control board and the front panel assembly
section.
1. Disconnect the wire from connector CN804 on the
main board.
2. Remove the plastic rivet fixing the headphone jack
board.
1-8
(See Fig.11 and 12)
(See Fig.13 and 14)
Fig.11
Front panel assembly
Joint d
Fig.12
Main board
CN804
Fig.13
Headphone jack board
Fig.14
Front panel assembly
Joint d
Headphone jack board
Plastic rivet