Advertisement
CH-DVD 300 Quick Setup Guide
1
Connect the DVD Player to
your TV
Use the AV (Audio/Video) cable
provided to connect the DVD player to
your TV as shown in the diagram.
Your TV must be equipped with AV
inputs like those pictured to the right in
order to connect this unit.
If your TV does not have AV inputs, you
will need a RF Modulator to connect this
player to your TV's antenna/cable input.
RF Modulators are available at major
electronics retailers.
2
Plug-in the Power Cord
Plug the DVD player's electrical
plug into a wall socket or power
strip.
3
Turn on the DVD Player and your TV
Press the POWER BUTTON on the front panel to turn the
DVD player on. The POWER LED should now change
from RED (STANDBY MODE) to GREEN (ON).
4
Select the VIDEO INPUT on your TV
The goal is to see the DVD player's splash screen on your
TV. To do this, select the Video Input channel on your TV
that corresponds with the input the player is plugged into.
This procedure differs among TVs, but is normally done by
pressing the VIDEO IN or INPUT button on the TV's remote
control to select the Video Input.
When the DVD player's splash screen appears on your TV,
you're ready to go!
TV
ANTENNA / CABLE IN
VIDEO R - AUDIO - L
CH-DVD 300
VIDEO
R
Y
S-VIDEO
L
COAXIAL
Pb/Cb
Pr/Cr
PROGRESSIVE SCAN
COMPONENT VIDEO OUT
POWER LED
TM
Advertisement
Table of Contents
Need help?
Do you have a question about the CH-DVD 300 and is the answer not in the manual?
Questions and answers
I get the DVD players splash screen on thde T.V. but nothing happens when I press play on remote
The CyberHome CH-DVD 300 DVD player is showing a splash screen but not responding because it may have encountered a malfunction after playing a burned DVD. The user mentioned that the player stopped working after using the emergency eject button. This suggests a possible hardware or firmware issue. A potential solution could be to try resetting the player or checking for any stuck components inside the disc tray.
This answer is automatically generated