Advertisement
Instruction on control panel functions
Control panel / Display
POWER
Plug the machine in and then press this key, the machine turns on.
Press this key again, it turns off.
Caution
1.If the machine is energized but not started, the power supply turns off automatically 5 min later.
2.If no key pressed after the START/PAUSE key is pressed during the running,
the power supply turns off automatically 10 min later.
START/PAUSE
Press this key after turning on, selected course is started.
Wash daily clothing like relatively-dirty shirts or pants.
NORMAL
Wash heavy and very dirty clothing.
JEANS
SPEEDY
Wash speedy for Not-so-dirty clothing.
DELICATE
Wash clothing with the HAND WASH mark.
Wash strong for blankets or heavy clothing.
BLANKET
Wash gently and rinse thoroughly for baby clothing.
BABYCARE
Course for cleaning washing / spin drying tub. Select the washing t im e: 2 hrs, 6 hrs, 9 hrs.
TUB CLEAN
WASH
Select WASH as necessary. Select the washing time: [ - ] = 0 min ,1 min – 15 min.
RINSE
Select RINSE as necessary. Select the rinsing time: [ - ] = 0 ,1 time – 3 times.
SPIN
Select SPIN as necessary. Select the spinning time: [ - ] = 0 min ,1 min – 9
6
[ - ] = 0 ,1
[ - ] = 0 , 1
min.
[ - ] = 0
,1
9
Common non-fault phenomenon (Please refer to this section
if you think an abnormality happens.)
Abnormal display
Caution
It generates a beep when washing machine indicates abnormal display. If not connected in 10 min, it turns off
automatically.
Because the phenomenon may not be a fault, please check it again before sending the machine
for repair. In the case of failure, please consult the maintenance department. Be sure not to disassemble and
repair the machine without permission.
Possible non-fault cause
Coping process
Presentation
Inclease water supply, press
Low flow at the faucet.
START / PAUSE key.
The faucet is closed.
Turn the faucet on, press
E1
START/PAUSE key.
Water inlet filter net
is blocked.
Clean filter net, press
START/PAUSE key.
Top cover is opened as the
reservation course starts.
E2
Close top cover.
Top cover is not closed
during spin drying.
The drain position is
Adjust drain hose properly,
relatively high.
press START/PAUSE key.
The end of drain hose is
E3
blocked.
Clean drain hose, press
Drain hose is folded/
START/PAUSE key.
crumpled/tied.
Washing machine place the
Washing machine inclines
horizontally with adjusting the
or is shaky.
foots.
E4
The clothing is lopsided.
Distribute the clothing evenly.
Pull out the plug from the plug
Water level sensor shows
seat, and entrust the main-
an abnormal level.
C2
tenance department.
Turn the power off, and take it
from the top.
Top cover opened in the
situation of CHILD LOCK.
U9
Caution
CHILD LOCK is not released,
unless you reset it manually.
Failure cause
List of failure cause
Get water in tube of
water level sensor
Circuit failure
Failure of water inlet
valve
Wiring disconnection
Connector contact
failure
Failure of water level
sensor
Failure of safety switch
Failure of drain valve
Failure of drain valve
motor
Connect failure on
drain valve motor
15
Advertisement
