Table of Contents
Advertisement
6. Turn the ignition key and hold it in the start position
(Fig. 5). When the engine starts, release the key.
Important
If the engine does not start after 10 seconds
of continuous cranking, turn the ignition key to off and let
the starter motor cool for 60 seconds. Refer to
Troubleshooting on page 36.
7. After the engine starts, move the choke lever to off.
Slowly move the throttle to the desired setting (Fig. 4).
If the engine stalls or hesitates, move the choke lever
back to on for a few seconds. Then move the throttle
lever to desired setting. Repeat this as required.
2
3
1
1206
Figure 3
1. PTO—Off
2. Choke–On
3. Choke–Off
1
Figure 5
1. Off
2. Lights
Stopping the Engine
1. Push the PTO (power take off) to off (Fig. 3).
2. Move the throttle lever to slow (Fig. 4).
3. Let engine idle for 30–60 seconds.
4. Turn the ignition key to off (Fig. 5).
1
2
1207
Figure 4
1. Fast
2. Slow
2
3
4
1208
3. Run
4. Start
16
Operating the
Power Take Off (PTO)
The power take off (PTO) engages and disengages power
to the electric clutch.
The PTO light, in the Indicator Module, will be on when
the ignition key is in run or lights position and the power
take off (PTO) is engaged. When this light is on it is a
reminder the starter will not crank and to turn the off PTO
before getting off the tractor.
Engaging the Power Take Off (PTO)
1. Depress the brake pedal to stop the machine.
2. Pull the power take off (PTO) to on (Fig. 6).
1
Figure 6
1. Off-Disengaged
Disengaging the Power Take Off (PTO)
1. Depress the brake pedal to stop the machine.
2. Push the power take off (PTO) to off (Fig. 6).
Checking the Safety Interlock
System
Caution
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
Do not tamper with the interlock switches.
Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
2
1206
2. On-Engaged
Advertisement
Table of Contents
