Table of Contents
Advertisement
Virtual flame technology
•
Virtual flame technology is available only on the right burner.
•
As you set the heat setting sensor to adjust the power level, the brightness of
the flames change.
The virtual flame may look different depending on the appearance, size, or
•
position of the cookware. (For the best results, use cookware that, matches the
element size. Cookware that is too large can cover the virtual flame. Cookware
that is too small can cause the virtual flame to be ill-formed.
•
Impurities on the cookware bottom or the cooktop surface can cause the
virtual flame to be ill-formed of incomplete. Clean up the cookware or the
cooktop surface before using them.
NOTE
If you want to turn off Virtual Flame technology, you must touch keep warm
sensor during 3 seconds as soon as you turn on the hob.
This function is available only immediately after turn on the hob. After another
action can not be set to function.
NOTE
Use a suitable cookware when using Virtual flame burner.
Size
Cookware surface
Material
When conditions are satisfied upper table, Virtual Flame shape can be formed
appropriately.
NZ63K7777BK_EU_DG68-00789A-00_EN.indd 15
Virtual flame technology creates the
appearance of flames when you turn on an
induction element.
200-220 mm
Horizontal hairline
STSS (Stainless steel)
Residual heat indicator
When an individual cooking zone or the hob is turned off, the presence of residual
heat is shown with an
,
(for "hot") in the digital display of the appropriate
cooking zones. Even after the cooking zone has been switched off, the residual
heat indicator goes out only after the cooking zone has cooled.
You can use the residual heat for thawing or keeping food warm.
WARNING
As long as the residual heat indicator is illuminated, there is a risk of burns.
WARNING
If the power supply is interrupted, the
about residual heat will no longer be available.
However, it may still be possible to burn yourself. This can be avoided by always
taking care when near the hob.
Temperature detection
If for any reason the temperatures on any of the cooking zones were to exceed the
safety levels, should this happen then the cooking zone will automatically reduce
to a lower power level.
When you have finished using the hob, the cooling fan will continue to run until
the hob's electronics has cooled down. And the cooling fan switched itself off
depending upon the temperature of the electronics.
,
symbol will go out and information
English 15
2/29/2016 11:26:13 AM
Advertisement
Table of Contents
