Electrical Safety; Using An Extension Cable; Assembly And Adjustments - DeWalt DCL508 Original Instructions Manual

Do Not use under wet conditions or in presence of flammable liquids
or gases.
Do Not let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
• This product is not intended for use by persons (including children)
suffering from diminished physical, sensory or mental abilities,
or for lack of experience and/or for want of knowledge or skills
unless they are supervised by a person responsible for their safety.
Children should never be left alone to play with this product.

electrical safety

The product has been designed for one voltage only. Always check that
the battery pack voltage corresponds to the voltage on the rating plate.
Also make sure that the voltage of your charger corresponds to that of
your mains.
Your D
EN 60335; therefore no earth wire is required.
If the supply cord is damaged, it must be replaced by a specially
prepared cord available through the D

using an extension Cable

An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see Technical Data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.

asseMBly and adjustMents

WARNING: Use only D
WALT charger is double insulated in accordance with
e
WALT service organisation.
e
WALT battery packs and chargers.
e
Eng li s h
;
2
13