Charging Process - DeWalt DCL508 Original Instructions Manual

E ngl i s h
Charging Procedure (fig. 2)
1. Plug the charger into an appropriate outlet before inserting battery
pack.
2. Insert the battery pack (b) into the charger. The red (charging) light
will blink continuously indicating that the charging process has
started.
3. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be
used at this time or left in the charger.
NotE: To ensure maximum performance and life of Li-Ion batteries,
charge the battery pack fully before first use.

Charging Process

Refer the table below for the state of charge of the battery pack.
State of charge
charging
fully charged
hot/cold pack delay
replace battery pack
hot/Cold Pack delay
When the charger detects a battery that is too hot or too cold, it
automatically starts a Hot/Cold Pack Delay, suspending charging until
the battery has reached an appropriate temperature. The charger then
automatically switches to the pack charging mode. This feature ensures
maximum battery life.
li-ion Battery PaCks only
Li-Ion batteries are designed with an Electronic Protection System
that will protect the battery against overloading, overheating or deep
discharge.
The tool will automatically turn off if the Electronic Protection System
engages. If this occurs, place the Li-Ion battery on the charger until it is
fully charged.
8
– – – –
–––––––––––
–– – –– –
•••••••••••