Connecting The Water Supply Hose (Clean Filter) - Samsung WA60H4100H User Manual

installation & maintenance

CONNECTING THE WATER SUPPLY HOSE (CLEAN FILTER)

1. Release all 4 screws from the connector.
2. Lift the connector up to the top end of the tap water
faucet.
• Fasten the screws while lifting the connector up.
• Lift it up until it clicks.
3. Fasten the screws.
• You should fasten the 4 screws to the same depth.
• Set the connector so that the plastic screws (1) and
(2) cannot be reached by a screwdriver as shown
by the fi gure, fasten the plastic screws by hand,
and then fasten the other screws (3) and (4) with a
screwdriver.
4. Connect the water supply hose to the connector while
holding down the catch and releasing the catch.
• The hose and connector are assembled with a
clicking sound.
• Be careful not to exchange the hot and the cold water
hoses by mistake.
• Do not connect the hot water only.
CAUTION
• The clean fi lter is highly effective to remove foreign substances from the tap water.
• The clean fi lter is only for cold water.
• If water leaks after making the connection, please connect it again.
• If the size of the connect does not match with the tap water faucet, please buy a faucet
from your nearby hardware store.
• The clean fi lter is not applied to built-in models.
WA4000H-03636A_EN (India)_150821.indd Sec10:18 WA4000H-03636A_EN (India)_150821.indd Sec10:18
English - 18
Connector
Clean fi lter
Catch
For general For the
purposes clean fi lter
After the
connection
For general For the
purposes clean fi lter
2015-08-21 2015-08-21 4:29:38 4:29:38