Table of Contents
Advertisement
Installation Procedures
Installing Lamp
In the event the lamp was packed separately during shipment, follow the procedure in this section.
WARNING: Disconnect fixture before relamping. AVERTISSEMENT: Déconnectez le projecteur avant que le changement de lampe.
WARNING: Hot Lamp. Luminaire must remain powered on for 5 minutes after dousing lamp. Do not open for 5 minutes after switching
off. AVERTISSEMENT: Lampe chaude. Le luminaire doit rester en marche pendant 5 minutes après avoir éteindre la lampe. Ne pas ouvrir
pendant 5 minutes après la coupure.
WARNING: Risk of exposure to excessive ultraviolet radiation. Do not operate without complete lamp enclosure in place or when lens is
damaged. AVERTISSEMENT: Risque d'exposition aux rayonnements ultraviolets excessifs. Ne pas faire fonctionner sans le boîtier
complet de lampe mis en place ou lorsque l'objectif est endommagé.
Note: Wear cotton gloves or other covering while installing lamp. Touching lamp glass with bare fingers will leave oil and may cause the
lamp to explode or reduce lamp life. If touched, use isopropyl alcohol and cotton cloth to thoroughly clean glass portion of lamp.
To install lamp:
Step
1. Ensure power is completely removed from luminaire.
Step
2. Remove lamp from shipping box.
Step
3. Set the luminaire head horizontally.
Step
4. Engage tilt lock to secure luminaire head in position.
Step
5. At back of luminaire, using #2 Phillips screwdriver, remove lamp socket cover by loosening the two quarter-turn captive
screws. Note: lamp socket cover is connected with a safety tether.
0 2. 9708.0001
VARI❋LITE - VL6000 B
Note: *lamp socket cover is connected with a safety tether
Figure 4: Lamp Socket Cover Removal
27 A p r il 2 0 1 7
L
Q
S
EAM
UMINAIRE
UICK
Lamp Socket
Lamp
Lamp Socket Cover*
Quarter-Turn Screws
G
TART
UIDE
8
Advertisement
Table of Contents
