Table of Contents
Advertisement
VARI❋LITE - VL6000 B
Menu Operation
LCD Display and Menu System
The VL6000 Beam Luminaire's LCD Display and Menu System provides local control for accessing the following fixture's settings:
•
Address – to set the DMX address
•
Configure – various parameter settings, set luminaire ID
•
Fixture – fixture status, recalibrate, reboot, software version, view fixtures hours, etc.
•
DMX – change the map, set address, invert pan/tilt
•
Service – password protected factory service menu
•
Manual – manual control of parameters
•
Test – test functions of parameters
The menu system is controlled at the Menu Display available at the enclosure input panel. If there are multiple luminaires in a system, any
settings or changes would need to be made at each LCD Menu as desired.
Menu Controls
The menu system is controlled by an OK (Enter), ESC (Escape), and four Arrow () buttons. These buttons function are shown in
Figure 14.
LCD Menu Proximity Sensor
Automatically enables the menu display (turn on
the backlight) as you reach for the front panel.
LCD Display
Displays all Data and
Luminaire Settings
Escape (ESC)
Used to Access Main Menu Parameters,
Exit, or Return to Previous Menu Item
LCD Display and Menu System Operation
The LCD Display Menu system consists of several categories. Use the Menu Buttons to access and make changes to the menu items. When
the desired menu item is reached, press the desired Menu Button to display the menu options and to navigate and configure the menu options
as required.
To navigate and access menu settings/selections:
Step
1. Make sure unit is powered and turned on.
Step
2. Press [ESC] to access menu categories.
Step
3. Use four Arrow () buttons to navigate through the various options and settings.
Step
4. Once menu item is reached, press OK [Enter] to access the menu item parameters.
Step
5. Make changes to parameters as desired.
Step
6. Press OK [Enter] button to accept changes.
15
L
Q
S
EAM
UMINAIRE
UICK
27 A pr i l 2 0 1 7
G
TART
UIDE
Figure 14: Menu Control
Arrow Keys (Up/Down/Left/Right)
Menu Navigation / Data Selection
ESC
OK
OK (Enter) Button
To Select or Change a
Setting or Data Value
0 2 . 9 7 0 8 . 0 0 0 1
Advertisement
Table of Contents
