Advertisement
(7) Take notes of the I/O range, then press Cancel button to
close the Property Setting window.
Take notes of the I/O
range shown here
(8) Open the folder where DDD is installed in Explorer etc
(Usually the folder is C:\Program Files\ Hitachi DDD- SI )
(9) Open the input folder in Hitachi DDD- SI.
1-14 (No.YF058)
Open the input folder
(10) Select all the files in the input folder and delete them all.
NOTE:
These files are used for other hard disks. If they are start-
ed up carelessly, it may cause serious impact on the
hard disk or other connected devices.
Therefore, prevent any operation mistakes by deleting all
the files except the one which is used with Microdrive.
(11) From the DDD SETUP folder, copy the two files
"FullCheckMicrodrive__jvc.pid" and "CleanDisk..pif" in the
input folder.
Inside the DDD SETUP folder
Input folder located under the DDD installed folder
(12) Double click the copied icon "FullCheckMicrodrive_jvc" on
the desktop to start DDD.
Select all the files the folder
and delete
Advertisement
