Electrolux EHD90230P User Manual page 5

Switching the appliance on and off
Control panel
To switch
Touch
on
To switch
Touch
off
After switching on, within approx. 10
seconds a heat setting or a function
must be set, otherwise the appliance au-
tomatically switches itself off.
Setting the heat setting
The control bar is touched where the desired
heat setting is positioned. The heat setting is
shown in the display. Correct to the left or the
right, if necessary. Do not release before the
desired heat setting is reached.
Locking/unlocking the control panel
The control panel, with the exception of the
"On/Off" sensor field, can be locked at any
To switch on
Touch
To switch off
Touch
When you switch the appliance off, the locking function is automatically switched off.
Switching the STOP+GO function on and
off
The STOP+GO function simultaneously
switches all cooking zones that are switched
Control panel
To switch on
Touch
To switch off
Touch
STOP+GO does not stop the Timer
function.
Using the automatic warm-up function
All cooking zones are equipped with an au-
tomatic warm-up function. When setting a
heat setting using the automatic warm-up
Indicator lights up. The operational readiness indicators of
for 1 second
the individual cooking zones also light up.
Indicator goes out. The operational readiness indicators of
for 1 second
the individual cooking zones also go out.
Control panel
Heat setting that was previously set (not automatic warm up
function)
Display
time in order to prevent the settings being
changed e.g. by wiping over the panel with a
cloth.
Indicator lights up
Indicator goes out
on to the keep warm setting and then back
to the heat setting that was previously set.
Display
STOP+GO locks the whole control panel
except the sensor field
function, the cooking zone switches to full
power for a certain amount of time and then
automatically switches back to the heat set-
ting set.
electrolux 5
Display
.