Electrolux EHD90230P User Manual page 12

12 electrolux
Problem
Repeated acoustic signal (6x),
appliance switches off
Acoustic signal sounds and ap-
pliance switches itself on and
then off again; after 5 seconds
another acoustic signal sounds
Display is switching between two
heat settings
lights up
and number are displayed
If you are unable to remedy the problem
by following the above suggestions,
Warning! Repairs to the appliance are only to be carried out by qualified service
engineers. Considerable danger to the user may result from improper repairs.
If the appliance has been operated incorrectly, the engineer's visit will be chargeable,
even during the warranty period.
Operating noises
Depending on the material and the process-
ing of the base, the following noises may oc-
cur when using induction cooking zones.
Possible cause
One or more sensor fields have
been covered for longer than 10
seconds
The On/Off sensor field has
been covered up, e.g. by a cloth
Power management is reducing
the power of this cooking zone
Unsuitable cookware
No cookware on the cooking
zone
Diameter of the base of the
cookware is too small for the
cooking zone
Overheating protection for the
cooking zone has been trig-
gered
Automatic switch-off has been
triggered
Electronics fault
please contact your dealer or the Cus-
tomer Care Department.
• Cracking noise
when using cookware made of different
materials (Sandwich construction)
Uncover sensor field
Do not place any objects on the
control panel
See the section "Switching the
power function on and off"
Use suitable cookware
Put cookware on zone
Move to smaller cooking zone
Use suitable cookware
Switch off the cooking zone.
Switch the cooking zone on
again
Switch appliance off. Switch ap-
pliance on again
Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of the
house's wiring system) If after
switching on again,
played again, call the customer
service department
1
1
Remedy
is dis-
2
3