Table of Contents
Advertisement
SETTING WOL
Refer to the following procedure to enable WOL.
When the system is Windows Server 2008 64-bit (x64) Edition / Windows Server 2008
32-bit (x86) Edition
1.
Start Device Manager.
2.
Point to [Network adapters] and double click [Intel(R) 82576 Gigabit Dual Port Server
Network Connection]/[Intel(R) 82576 Gigabit Dual Port Server Network Connection #2]
to open the adapter [Properties].
3.
Click [Power Management] tab and change setting in [Wake On LAN] according to the
following list.
Setting item
"Wake On Directed Packet"
"Wake On Magic Packet"
"Wake on Magic Packet from power
off state"
NOTES:
[Power Saver Options] setting is not necessary to change.
Above setting will maintained until manually resetting are executed.
IMPORTANT:
the network port are not available of WOL.
4.
Click [OK].
5.
Reboot the system.
IMPORTANT:
WOL (Wake On Lan) are only available on system Shutdown mode.
WOL (Wake On Lan) is not available on system Hibernate and Sleep
mode.
The parameters of [Wake On LAN] will not exist, if
Installing the Operating System B-47
Default setting
ON
ON
OFF
Change setting
OFF
OFF
ON
Advertisement
Table of Contents
