Table of Contents
Advertisement
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
9.
Install the right side cover and the shroud.
To change the engine oil (with or without oil fil-
ter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Remove the shroud, the left side cover,
the right side cover, and the drive guard.
(See pages 17 and 44 for removal proce-
dures.)
4.
Remove the left lower cover, the right
lower cover, and the bottom panel.
2
4
3
1. Left lower cover
2. Quick fastener
3. Bolt
4. Washer
Periodic maintenance and adjustment
3
1
2
1. Right lower cover
2. Quick fastener
3. Bolt
4. Washer
2
1. Bottom panel
2. Quick fastener
5.
Place an oil pan under the oil tank to col-
lect the used oil.
6.
Disconnect the oil level gauge coupler.
1. Oil level gauge coupler
2. Oil filler cap
1
3
3
2
4
51
Advertisement
Table of Contents
