Table of Contents
Advertisement
TCD320FX(e).book Page 34 Tuesday, January 18, 2005 1:25 PM
Base Unit Settings
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4
Select "Call Options", then press
,.
5
Select "Emergency No.", then press
,.
6
Select a memory location, then press
,.
L If the memory location already
contains an emergency number, the
number is displayed.
7
Enter/edit the number, then press ,.
L To erase an emergency number, press
and hold {C/T}.
8
Press {ih}.
Setting call restriction
You can restrict selected handsets from
dialling certain numbers. You can assign up
to 6 phone numbers to be restricted, and
select which handsets will be restricted.
Storing area codes here will prevent the
restricted handsets from dialling any phone
number in that area code. If a restricted
number is dialled, the call will not be
connected and the restricted number will
flash on the display.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it (page
34).
4
Select "Call Options", then press
,.
5
Select "Call Restrict", then press
,.
6
Set which handsets will be restricted by
pressing the desired handset number.
L All the registered handset numbers
will be displayed.
34
L Flashing numbers indicate call
restriction is turned on for the
corresponding handset.
L To turn call restriction off for a handset,
press the number again. The number
will stop flashing.
7
Press ,.
8
Select a memory location, then press
,.
L If the memory location already
contains a restricted number, the
number is displayed.
9
Enter the phone number or area code to
be restricted (8 digits max.), then press
,.
L To erase a restricted number, press
{C/T}.
10
Press {ih}.
Other options
Changing the base unit PIN
(Personal Identification Number)
For security, the base unit PIN must be
entered when changing certain settings. The
default PIN is "0000".
Important:
L If you change the PIN, please make note
of your new PIN. The unit will not reveal
the PIN to you. If you forget your PIN,
consult your nearest Panasonic service
centre.
1
Press $ (middle soft key).
2
Select Z, then press ,.
3
Enter "0000" (default base unit PIN).
L If you changed the PIN, enter it.
4
Select "Other Options", then press
,.
5
Select "Base Unit PIN", then press
,.
Advertisement
Table of Contents
