System Connections - Sharp XL-HF301PH Operation Manual

System connections

Make sure to unplug the AC power lead before making any connections.
Right
speaker
■ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
■ Speaker connection
● Connect
the wire
insulation tube to the minus (–)
terminal, and the wire with red
insulation tube to the plus (+)
terminal.
● Use speakers with an impedance
of 4 ohms or more, as lower
impedance speakers can damage
the unit.
● Do not mistake the right and the
left channels. The right speaker is
the one on the right side when you
face the unit.
● Do not let the bare speaker wires touch each other.
● Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
● Do not stand or sit on the speakers. You may be
injured.
FM aerial
without
Incorrect
Video cable
(not supplied)
To video input socket
■ Demonstration mode
● The first time the unit is plugged in, the unit will enter
the demonstration mode.
● To cancel the demonstration mode, press the DEMO/
DIMMER button (remote control) during power stand-
by mode. The unit will enter the low power consumption
mode.
● If iPod or iPhone is docked, the unit will begin charging.
"Charge Mode" will displayed. Demonstration mode is
invalid during charge mode.
● To return to the demonstration mode, press the DEMO/
DIMMER button again.
■ Connecting iPod or iPhone to TV
Photo and video files from iPod or iPhone can be viewed
by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket at the back of the unit and set the TV Out on
the iPod or iPhone unit to "ON" position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple's homepage for
further information.
■ AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
E-4
TV
Left
speaker
Red
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)