Tow With A Tow Truck - Cupra BORN Owner's Manual

Hide thumbs Also See for BORN:
Table of Contents

Advertisement

tow cable should only be used if a tow bar is
not available.
A tow rope should be slightly elastic to avoid
damage to both vehicles. It is advisable to
use a tow rope made of synthetic fibre or
similarly elastic material.

Tow with a tow truck

The vehicle may only be transported on a on
a tow truck if all four wheels are supported.
WARNING
During the towing of a vehicle, the driving
behaviour and braking capacity change
considerably.
WARNING
Never allow the vehicle to be towed if it has
no power.
When towing, never switch off the igni-
tion with the ignition/start button. Other-
wise, the electronic lock of the steering
column could suddenly get blocked and it
would be impossible to steer the vehicle.
This could cause an accident, serious injury
and loss of control of the vehicle.
If the vehicle runs out of power during
towing, stop the process immediately and
seek the assistance of specialised person-
nel.
252
Owner's manual
CAUTION
Towing the vehicle with a tow cable or a tow
bar can cause damage to the vehicle.
If the vehicle is towed with a tow cable or
tow bar, special care must be taken.
If possible, have the vehicle transported
on a tow truck.
CAUTION
If the vehicle is pushed by hand, the tail
light units, the side spoilers of the rear win-
dow and large sheet metal surfaces may be
damaged. In addition, the rear spoiler could
be detached.
If the vehicle is pushed by hand, the tail
light units, the side spoilers of the rear win-
dow, large sheet metal surfaces or the rear
spoiler.
CAUTION
Removing and attaching the cover and the
towing eye may cause damage to the vehi-
cle, for example, on the paintwork.
To avoid damaging the vehicle, remove
and replace the cover and the towing eye
carefully.
CAUTION
Using a towing eye that is not suitable for
the vehicle can damage it.
When towing, always use the vehicle's
towing eye, which forms part of the on-
board tools, or an appropriate eye for tow-
ing.
Towing instructions
During towing, the change of direction can
be signalled on the towed vehicle even when
the hazard warning lights are on. To do so, at
the same time, the turn signal lever must be
operated with ignition switched on. During
this time the hazard warning lights remain
disconnected. When the turn signal lever is
returned to the rest position, the hazard
warning lights will be automatically reactiva-
ted.
Cases where the vehicle must never be
towed
Do not allow the vehicle to be towed for a
long distance on its wheels in the following
situations:
A red warning light lights up on the instru-
ment cluster screen and a message is dis-
played:
The towing damages the elec-
trical system. Manual!
The power supply of the on-board 12-volt
electrical system cannot be guaranteed.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BORN and is the answer not in the manual?

Questions and answers

Gerry
January 29, 2025

Central locking takes some time to work in cold/freezing temperatures.I tend to pour lukewarm warm water over drivers door handle (manual key area)then after a few minutes it works but it’s not the key fob?

A Fuller
February 21, 2025

How to set speed limiter cupr a born 2023

2 comments:
Mr. Anderson
February 21, 2025

To set the speed limiter on a Cupra Born 2023:

1. Press the button to activate the speed limiter.
2. The system will store the selected speed, starting from 30 km/h (20 mph) and above.
3. The saved speed will be displayed on the instrument cluster.

The speed limiter can be temporarily overridden by fully pressing the accelerator pedal past the resistance point. It will reactivate automatically when the speed returns below the set limit.

This answer is automatically generated

Tony
February 21, 2025

How to set speed limiter on cupr A born 2023

Table of Contents

Save PDF