Glass Roof Sun Blind - Cupra BORN Owner's Manual

Hide thumbs Also See for BORN:
Table of Contents

Advertisement

Glass roof sun blind

On the interior roof lining: function
Fig. 90
button for operating the sun blind.
The electric sun blind operates while the ig-
nition is switched on and can be opened and
closed using the function button on the inte-
rior roof trim or from vehicle settings in the
infotainment system.
Opening and closing the sunshade blind
Automatic function: slide one finger across
the function button forwards (open) or back-
›››
wards (close)
Fig. 90
. Pressing the func-
tion button stops the automatic function.
Manual function: slide a finger across the
function button forwards (open) or back-
wards (close) and hold until the blind reaches
the desired position.
Visibility
Anti-trap function of the sunshade blind
The anti-trap function can reduce the risk of
injury when closing the sunshade blind
If the blind encounters resistance or an ob-
stacle when closing, it will reopen immedi-
ately.
Check why the blind did not close.
Try to close the blind again.
If the blind still cannot be closed due to an
obstacle or resistance, it will reopen immedi-
ately. Once open, it can be closed for a short
space of time without the anti-trap function.
If it is still not possible to close the blind,
close it without the anti-trap function.
Closing the sunshade blind without the
anti-trap function
Try to close the blind again.
If it still cannot be closed, within 5 seconds
slide the function button backwards without
›››
releasing it
Fig. 90
until the blind closes
fully. The blind closes without the inter-
vention of the anti-trap function!
If it is still not possible to close the blind,
visit a specialised workshop.
If the function button is released during clos-
ing, the blind opens automatically.
The button reacts differently than expec-
ted
›››
.
Moisture, dirt, grease, etc., can limit the op-
eration of the buttons. Make sure the but-
tons are always clean and dry.
WARNING
Closing the sun blind without the anti-trap
function can cause serious injury.
Always close the blind with care.
Do not allow anyone to remain in the
blind travel area, particularly when closing
without the anti-trap function.
The anti-trap function does not prevent
fingers or other parts of the body from be-
coming trapped against the roof frame and
injuries occurring.
119

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BORN and is the answer not in the manual?

Questions and answers

Gerry
January 29, 2025

Central locking takes some time to work in cold/freezing temperatures.I tend to pour lukewarm warm water over drivers door handle (manual key area)then after a few minutes it works but it’s not the key fob?

A Fuller
February 21, 2025

How to set speed limiter cupr a born 2023

2 comments:
Mr. Anderson
February 21, 2025

To set the speed limiter on a Cupra Born 2023:

1. Press the button to activate the speed limiter.
2. The system will store the selected speed, starting from 30 km/h (20 mph) and above.
3. The saved speed will be displayed on the instrument cluster.

The speed limiter can be temporarily overridden by fully pressing the accelerator pedal past the resistance point. It will reactivate automatically when the speed returns below the set limit.

This answer is automatically generated

Tony
February 21, 2025

How to set speed limiter on cupr A born 2023

Table of Contents

Save PDF