Mercia Garden Products HONEYSUCKLE PLAYHOUSE General Instructions Manual page 3

Nail Bag
PI-02-0352
60mm Screw x 2
50mm Screw x 30
40mm Screw x 40
30mm Screw x 57
30mm Black Screw x 14
20mm Screw x 15
10mm Screw x 4
Felt Tacks x 65
Pre Assembly
Before assembling remove the transportation
blocks from the bottom of each panel.
Step 1
To x the Windows (No. 22) into the panels
that accomodate a window. First x the
Window Block to the Window as shown
with 1x30mm screw.
Place the Window into the window hole
and x by screwing though the Window
Block (No. 23) with 2x30mm screws as
shown.
Screw into the Window rst.
12x30mm screws.
30mm
Pre drill
screw
hole
Please retain product label and instructions for future reference
Step 2
Lay joists (No. 10) under the oor sheet with an
even space between each one. Position
joists ush on one side of the oor sheet
and mark centers of joists onto either end.
Fix using 5 x 30mm screws per joist.
If purchased with a tower please read
both sets of instructions before
beginning assembly.
20x30mm screws.
30mm
Pre drill
screw
hole
Step 3
Lay the door gable face up on a at
surface, place the door within the door
aperture. Position the door so that you
have a 12mm gap from the door to the
door gable on all four sides.
Useful tip: Use a12mm thick piece of
timber from your xing kit within the
gaps to ensure the door does not
move.
Once you are happy the door is in the
correct position place a hinge at the top
and bottom of the door, ensuring the
screws will go into the framing (in cases
where you have been supplied three
hinges use the third in the middle of the
door) and using 30mm black screws x
the hinge to the door and the door gable.
14x30mm black screws
30mm
Pre drill
screw
hole
4
10
1
7
21
P 3