Storage ............................11 Parts Lists............................12 Product Records IMPORTANT: Record the information from the serial number plate of your Aerator Pro. It will be necessary to furnish your Model Designation, Product Number, and Serial Number when ordering parts. Aerator Pro Model Designation...
Intended Use: The Aerator Pro is a self-propelled tine type aerator. The Aerator Pro is intended to be used for the aeration of the turf or soil at a properly prepared worksite. The Aerator Pro is NOT intended to be used for any purpose other than the aeration of turf.
SAFETY AERATOR PRO Recognizing Safety Warnings Used In Manual LOOK FOR THE SAFETY HAZARD WARNING SYMBOL The symbol is used to alert the operator of safety hazards. It is used in conjunction with the words DANGER, WARNING, and CAUTION. DANGER...
Page 5
AERATOR PRO SAFETY Care should always be taken when mounting and Do not remove the fuel tank cap or fill fuel tank while dismounting a riding machine. Prevent injuries and the engine is hot or running. Allow the engine to cool falls by making sure the operator does not slip.
Remove all loose components from the crate. Before STEP 3. Install transport wheels on the wheel pivot removing the Aerator Pro from the crate bottom, the linkage. Wheels and axles should be spaced with a handlebar and transport wheels should be mounted to flat washer.
Page 7
AERATOR PRO ASSEMBLY CLUTCH CLUTCH CLUTCH SPRING "S"-HOOK REMOVABLE CLEVIS HAIR CABLE CABLE PIVOT WEIGHT ADJUSTER LINKAGE CLUTCH HANDLE (ENGINE SHOWN) FLAT WASHER AERATOR 1-1/8" CHASSIS LONG SCREW FLAT WASHER FLEXLOC HANDLEBAR WHEEL RIGHT SIDE AXLE TRANSPORT WHEEL LIFT TUBE SMALL 7/8"...
The Aerator Pro is a self-propelled coring tine type non-operational operator controls. aerator. The Aerator Pro is intended to be used for the aeration of the turf or soil at a properly prepared Engine Controls: The engine controls are all located worksite.
AERATOR PRO OPERATION Operation Locate and mark any shallow buried natural gas, WARNING propane gas, or other gas or fuel line that may be damaged by the aerating process. To Avoid Serious Injury, Read and Understand the Entire Operator's Locate and mark any shallow buried roof drain pipes, Manual Before Operating This Machine.
OPERATION AERATOR PRO AERATOR OPERATION INSTRUCTIONS unsafe manner, the Aerator Pro can tip, roll over, or roll back on to the operator, causing serious injury. DANGER When aerating on minor slopes, never operate straight up or down or across the slope. Approach a Always operate the Aerator safely.
AERATOR PRO SERVICE adjusting idler sprocket position, ensure that the chain Lubrication and all sprockets have been cleaned and that the chain seats properly on the sprockets. A build-up of WARNING dirt on the sprockets or chain can cause the chain to become too tight.
PARTS LISTS AERATOR PRO Handlebar Assembly LONG END OF LIFT TUBE TOWARDS THE BOTTOM 24 (LEFT SIDE ONLY)
Page 13
AERATOR PRO PARTS LISTS Handlebar Assembly Item Part Description Qty. 660093 Handlebar ....................1 400260 Screw, Hex, 3/8"-16 x 7/8" ................ 6 444810 Nut, Hex, 3/8"-16, Flexloc Full ..............10 660104 Handle, Wheel Lift ..................1 446142 Washer, Lock, 3/8" ..................2 452006 Washer, Flat, .375"...
Page 14
PARTS LISTS AERATOR PRO Transport Wheels 23 18 22...
Page 15
AERATOR PRO PARTS LISTS Transport Wheels Item Part Description Qty. 660091 Tube, Pivot, Wheel (Includes Item 2) ............1 650586 Oilite, Wheel Pivot Tube, AA-839-13 ............2 658240 Bolt, Carriage, 5/16-18 x 3/4" ..............4 444808 Nut, Hex, 5/16"-18 Flexloc Full ..............6 660098 Shaft, Wheel Pivot ..................
Page 16
PARTS LISTS AERATOR PRO Tine Reel Assembly CARRIAGE TINE BOLTS FORWARD ROTATION SPROCKET END OF TINE REEL TINE REEL DIAGRAM Item Part Description Qty. 660087 Tine Reel ....................1 87305 Tine, 1 Each ..................48 658599 Bolt, Carriage, 5/16"-18 x 1-1/2" ............96 658600 Nut, Hex, 5/16"-18 Thin Nyloc ...............
Page 17
AERATOR PRO PARTS LISTS Front Drum Assembly Item Part Description Qty. 660089 Shaft, Tank ....................1 658595 Gasket, 4-1/2" ..................1 658593 Ring, Split ....................2 658351 Tank, Water 20” ..................1 658538 Plug, Expansion, 1" ................. 1 658596 Gasket, 2-7/8" ..................1 658592 Flange, 2-7/8"...
Page 18
PARTS LISTS AERATOR PRO Clutch and Drive Train...
Page 19
AERATOR PRO PARTS LISTS Clutch and Drive Train Item Part Description Qty. 656162 Pulley, Engine, V-belt (Includes Set Screw) ..........1 415519 Screw, Set, 5/16"-18 x 3/8" (See Note A) ..........1 499086 Key, 3/16" x 1" ................... 1 660111 Guard, Belt ....................
Page 20
Washer, Flat, .312" ID x .750" OD x .062" Thick ......4 444808 Nut, Hex, 5/16"-18 Flexloc Full ............8 660101 Bumper, Front ................1 Bolt, Carriage, 5/16”-18 x 3/4” ............4 658240 660096 Weight, Removable, Aerator Pro ........... 1 659138 Pad, Rubber Vibration Bumper ............4...
Need help?
Do you have a question about the Aerator Pro and is the answer not in the manual?
Questions and answers