Table of Contents
Advertisement
Operation
4.
Pull the manual starter handle slowly un-
til you feel resistance. Then give a
strong pull straight out to crank and start
the engine. Repeat if necessary.
5.
After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
NOTE:
When the engine is cold, it needs to be
G
warmed up. For further information, see
page 35.
If the engine is warm and fails to start,
G
open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 74.
6.
Slowly return the throttle grip to the fully
closed position.
EMU27602
Electric start/prime start models
1.
Place the gear shift lever in neutral.
32
ZMU05600
NOTE:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2.
Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
EWM00121
WARNING
Attach the engine shut-off cord to a se-
G
cure place on your clothing, or your
ZMU05536
arm or leg while operating.
Do not attach the cord to clothing that
G
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
G
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
N
ZMU05533
Advertisement
Table of Contents
